ISO 9001:2015 · AWS D1.6 · ASME BPVC Section IX qualified. Oak Harbor, Ohio.
Each page names the products we fabricate for that sector and the proof behind them.
Featured Industry
Mixer housings, hoppers, and process frames in 304/316L: full-penetration GTAW on product-contact welds when the spec calls for it, then bead-blasted and pickled in-house.
Featured Industry
Troughs, weirs, clarifier components, and dosing skids in 304L, 316L, and duplex 2205, rolled to hold straightness and pickled as a whole assembly.
More industries we serve
Exhaust duct, tower internals, and process spools in 304, 316, duplex, and Hastelloy, welded to ASME Section IX procedures.
Scrubbers, quench vessels, stack liners, and demister housings for acid-dew-point service, pickled and passivated in-house.
Mirror-polished facade panels, sculptural work, and AESS members with finish samples matched to the architect-approved master.
Process tanks, chutes, and vacuum boxes in duplex 2205/2507, welded to hold ferrite balance in liquor and bleach service.
CIP skids and hygienic housings with crevice-free full-penetration GTAW and specified Ra finishes, passivated per ASTM A380/A967.
Corrosion-resistant alloys, AWS D1.6 structural weldments, and heavy-gauge fabrication for hard-service environments.
Process vessels, heat exchangers, and pipe spools in duplex 2205, Hastelloy C-276/C-22, and AL-6XN, with PMI and in-house pickling.
Beams, pipe racks, platforms, and walkways welded to AWS D1.6 with CWI-overseen distortion control in the stainless-only bay.
Large-diameter scrubber and stack duct in 304L, 316L, duplex, and AL-6XN, dry-fit in the shop before it leaves the dock.
Burner assemblies and furnace internals in 321, 347, Inconel 625, and Hastelloy C-22/C-276, GTAW under ASME Section IX.
Oven and furnace equipment in 304L, 309S, and alloy 625, and precision weldments for aerospace, research, and instrumentation programs.
Oven panels, furnace nozzles, and thermal tooling in 304L, 309S, and alloy 625, welded to hold flatness through the heat.
Rolled cones, precision 316L tube weldments, and airframe structures, trial-fit on the floor and radiographed where the print demands it.
